Perle Systems Sds4 Manuel d'utilisateur télécharger pdf (Page 80)

Getting Started 79

Setting Up the Network

Using a Direct Serial Connection to Enable BOOTP/DHCP

If you are using BOOTP, you need to add an entry in the BOOTP server for the IOLAN that

associates the MAC address (found on the back of the IOLAN) and the IP address that you want to

assign to the IOLAN. After you have made the MAC address/IP address association for BOOTP, use

the following directions for BOOTP or DHCP.

You can connect to the IOLAN using a PC with a terminal emulation package, such as

HyperTerminal or a dumb terminal.

1. Connect the IOLAN to your PC or dumb terminal. Make sure the DIP switch is in Console mode

(for desktop models, this sets the IOLAN serial port to EIA-232) or that you are connected to the

dedicated Console port (for rack mount models). When connecting a terminal or PC directly

(without modems), the EIA-232 signals need to be crossed over (‘null modem’ cable). See

Appendix D, EIA-232 Cabling Diagrams for cabling diagrams.

2. Using a PC emulation application, such as HyperTerminal, or from a dumb terminal, set the Port

settings to 9600 Baud, 8 Data bits, No Parity, 1 Stop Bits, and No Hardware Flow control to

connect to the IOLAN. You can change these settings for future connections on the rack mount

models (the IOLAN must be rebooted for these changes to take place).

3. When prompted, type admin for the User and superuser for the Password. You should now see

the a prompt that displays the model type and port number; for example,

SCS16#.

4. You are now logged into the IOLAN and can set the IP address by typing from the command line

using the Command Line Interface (CLI). Type the following command:

set server internet dhcp/bootp on

5. Type the following command:

save

6. Type the following command:

reboot

7. When the IOLAN reboots, it will automatically poll for an IP address from the DHCP/BOOTP

server. If the IOLAN has dual Ethernet, each Ethernet connection will automatically be assigned

an IP address, you can access the IOLAN through either IP address.

8. To view the DHCP/BOOTP assigned IP address, type the following command:

show interface ethernet

If for some reason it cannot obtain an IP address from your DHCP/BOOTP server, you will have to

either reconnect to the IOLAN on the console port and reboot it or push the RESET button to access

the IOLAN.

You are now ready to configure the IOLAN. See Chapter 3, Configuration Methods for information

on the different IOLAN configuration methods.

Note:

This procedure does not apply to IOLAN medical unit models.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 459 460

Pas de commentaire

Perle Systems Sds4 Manuel d'utilisateur Page 80