Perle Systems Sds4 Manuel d'utilisateur télécharger pdf (Page 358)

100

101

357

Setting Up Printers

6. Next you need to create a gateway and destination route entry. Select Network, Advanced, and

the

Route List tab.

For the destination, if you want the connection to be able to reach any host in the remote

network, set the

Type to Network and specify the network IP address and subnet/prefix bits; if

you want the connection to go directly to a specific remote host, set the

Type to Host and specify

the host’s IP address.

We want a specific host to the be destination, so we configured the Type as Host:

We also need to create a Gateway entry using the same PPP IPv4 local IP address. Any traffic

that goes through the gateway will automatically cause PPP to dial out:

Setting Up Printers

The IOLAN can communicate with printers on its serial ports using LPD and RCP protocols, as well

as print handling software using TCP/IP.

Remote Printing Using LPD

When setting up a serial line that access a printer using LPD, do the following:

1. Set the serial port to Printer and configure the Speed, Flow Control, Stop Bits, Parity, and Bits

parameters so that they match the printer’s port settings.

2. Save your settings and restart the serial port.

3. Verify that LPD has been configured on the network host. To configure LPD on the network

host, you need to know the name or IP address of the IOLAN and the print queue, either

raw_p<port_number> for a raw data connection or ascii_p<portnumber> for an ASCII

character connection. If you want to direct output to a hunt group, omit the port number(s). For

example: raw_p or ascii_p. You can optionally append

_d or _f to the queue name to add a

<control d> or <form feed> to the end of the print job.

4. To execute a print job on a UNIX Linux system, use the following syntax:

lp -d raw_p<port_number> <filename>

1 2 ... 353 354 355 356 357 358 359 360 361 362 363 ... 459 460

Commentaires sur ces manuels

Pas de commentaire

Perle Systems Sds4 Manuel d'utilisateur Page 358

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Perle Systems Sds4