Perle Systems Sds4 Manuel d'utilisateur télécharger pdf (Page 218)

217

Adding/Editing Users

TCP Port When the User Service is Telnet, this is the target port number. The default

value will change based on the type of

Service selected; the most common

known port numbers are used as the default values.

IPv4 Address Used for User Service PPP or SLIP, sets the IP address of the remote user.

Enter the address in dot decimal notation as follows:

z n.n.n.n—(where n is a number) Enter the IP address of your choice. This

IP address will then be used in preference to the

Remote IP Address set

for a line.

The following IP addresses have a special meaning:

z 255.255.255.254—The IOLAN will use the Remote IP Address set in the

PPP settings for the serial port that this user is connecting to.

z 255.255.255.255—When the User Service is PPP, the IOLAN will allow

the remote machine to specify its IP address (overriding the IP address

negotiation value configured in the

PPP settings).

z 255.255.255.255—When the User Service is SLIP, the IOLAN will use

the

Remote IP Address set for the line (no negotiation).

Default: 255.255.255.254

IPv4 Subnet Mask If the remote user is on a subnet, enter the network’s subnet mask. For

example, a subnet mask of 255.255.0.0.

IPv6 Interface

Indentifier

Used for User Service PPP, sets the IPv6 address of the remote user. Enter the

address in IPv6 format.

Field Format: The first 64 bits of the Interface Identifier must be zero,

therefore, ::abcd:abcd:abcd:abcd is the expected format.

MTU Used for User Service PPP or SLIP, specifies the maximum size of packets, in

bytes, being transferred across the link. On noisy links it might be preferable to

fragment large packets being transferred over the link, since there will a be

quicker recovery from errors.

Data Options:

z PPP—MTU will be the maximum size of packets that the IOLAN will

negotiate for this port. This value is negotiated between the two ends of

the link.

z SLIP—MTU will be the maximum size of packets being sent by the

IOLAN.

The

User MTU value will override the MTU/MRU values set for a Serial Port.

Range: PPP: 64-1500 bytes, SLIP: 256-1006 bytes

Default: PPP is 1500 bytes, SLIP is 256 bytes

Routing Determines the routing mode used for RIP packets on the PPP and SLIP

interfaces. Values are:

z None—RIP packets are neither received nor sent by the IOLAN.

z Send—RIP packets can only be sent by the IOLAN.

z Listen—RIP packets can only be received by the IOLAN.

z Send and Listen—RIP packets are sent and received by the IOLAN.

Default: None

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 459 460

Commentaires sur ces manuels

Pas de commentaire

Perle Systems Sds4 Manuel d'utilisateur Page 218

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Perle Systems Sds4