Perle Systems Sds4 Manuel d'utilisateur télécharger pdf (Page 34)

Hardware and Connectivity 33

Power Supply Specifications

Available Accessories

The following accessories are available for purchase for the various IOLAN models (except medical

unit models):

z DIN Rail Mounting Kit (35mm) for the desktop models and Electric Utility models.

z IOLAN modem card for SCS rack mount models

z PCI adapter card for SCS rack mount models (for wireless WAN cards, modem cards and fiber

LAN cards)

z 3 meter RJ45M-RJ45M 8-wire Sun/Cisco modular cable

z RJ45 to DB25 DTE Male adapter

z RJ45 to DB25 DCE Male adapter

z RJ45 to DB25 DTE Female adapter

z RJ45 to DB9 Male DTE adapter

z RJ45 to DB9 Female DTE adapter

Contact your distributor for details.

Power Supply Specifications

Desktop Models

If you are providing a power supply for a desktop IOLAN model, your power supply must meet the

following requirements:

z DC barrel connector: The cable attached to the power supply should be about 20AWG. The

barrel dimensions of the cable-plug are OD=5.5, ID=2.1, and length= 9.5mm, with a straight

barrel, and positive polarity on the inside and negative polarity on the outside. The voltage

output should be between 9-30V DC and a minimum of 600 mA.

z Terminal Block connector: The cable attached to the power supply should be about 20AWG.

See the Quick Start Guide for your model to determine the power requirements

z Power can also be provided by:

z Serial Port 1, pin 1 on the DS/SDS1 models

z Serial Port 2, pin 1 on the SDS2 model

z Serial Port 4, pin 1 on the SDS4/SCS4 /SCS4 HL models

z Ethernet on the P series models (Power over Ethernet)

Power Over Ethernet (PoE) Models

The 1-port/4-port SDS P models can be powered by either the external DC power supply (not

included) or PoE or both. The 2-port SDS P does not accommodate an external power supply and can

be powered only through PoE.

The IOLAN SDS P model is considered a Powered Device (PD) and can only accept power from an

IEEE 802.3AF compliant Power Source Equipment (PSE) device. The IOLAN PoE can receive up to

13W of power using one of the following methods to connect to a PSE:

z Using the two unused twisted pair wires (10/100Mb only).

z Using the two data pairs or “phantom power” method (100Mb).

Note:

Explosion WARNING

SDS4 HL model ONLY.

Do not disconnect while circuit is live unless area is known to be non-hazardous.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 459 460

Commentaires sur ces manuels

Pas de commentaire

Perle Systems Sds4 Manuel d'utilisateur Page 34

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Perle Systems Sds4