Perle Systems Sds4 Manuel d'utilisateur télécharger pdf (Page 68)

100

101

Configuration Methods 67

DHCP/BOOTP

DHCP/BOOTP Parameters

The following parameters can be set in the DHCP/BOOTP bootp file:

z SW_FILE—The full path, pre-fixed by hostname/IP address (IPv4 or IPv6), and file name of the

firmware update.

z CONFIG_FILE—The full path, pre-fixed by hostname/IP address (IPv4 or IPv6), and file name

of the configuration file.

z GUI_ACCESS—Access to the IOLAN from the HTTP or HTTPS WebManager. Values are on

off.

z AUTH_TYPE—The authentication method(s) employed by the IOLAN for all users. You can

specify the primary and secondary authentication servers, separated by a comma. This uses the

following numeric values for the authentication methods.

–0—None (only valid for secondary authentication)

–1—Local

–2—RADIUS

–3—Kerberos

–4—LDAP/Microsoft Active Directory

–5—TACACS+

–6—SECURID

–7—NIS

z SECURITY—Restricts IOLAN access to devices listed in the IOLAN’s host table. Values are

yes or no.

z TFTP_RETRY—The number of TFTP retries before aborting. This is a numeric value, for

example, 5.

z TFTP_TMOUT—The time, in seconds, before retrying a TFTP download/upload. This is a

numeric value, for example, 3.

z CUSTOM_LANG—The full path, pre-fixed by a hostname/IP address (IPv4 or IPv6), and file

name of a translated language file. For example,

192.101.34.211 /accounting/Iolan_ds_german.txt.

z EXTRA_TERM1—(EXTRA_TERM2, EXTRA_TERM3) The full path, pre-fixed by a

hostname/IP address (IPv4 or IPv6), and file name of a termcap file for a specific terminal type.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 459 460

Commentaires sur ces manuels

Pas de commentaire

Perle Systems Sds4 Manuel d'utilisateur Page 68

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Perle Systems Sds4