Perle Systems Sds4 Manuel d'utilisateur télécharger pdf (Page 443)

Troubleshooting 442

SSL/TLS

If you are experiencing problems obtaining a successful SSL/TLS connection, you can set your

Syslog Level to Notice and view the syslog for the following messages:

Line not SSL enabled. Abort connection when a user who is configured for Service SSL_RAW

tries to login on the serial port.

The user has been configured for an SSL_RAW connection, but the line has not been configured to

enable SSL. To resolve this, either enable the line for SSL or change the user's

Service to

TCP_CLEAR if SSL is not wanted.

Could not obtain peer's certificate.

z User has selected a cipher key exchange of ADH (anonymous Diffie-Hellman) and enabled Peer

verification. ADH does not use certificates so they will not be sent in an SSL/TLS handshake.

Disable Peer Verification or change to a cipher suite that uses certificates.

z User has selected Peer Verification on the configured SSL/TLS server and has not configured a

certificate for the client. Either disable peer verification on the SSL/TLS server or configure a

certificate for the SSL/TLS client.

SSL_accept failed on the SSL/TLS server device.

z The device has failed to accept an SSL/TLS connection on top of a TCP connection that has just

been established. This could indicate that the peer from which TruePort is trying to accept a

connection from is not configured for SSL/TLS. Verify that the peer has been configured for an

SSL/TLS client connection.

Certificate did not match configuration

z The message is displayed when Validate Peer Certificate has been enabled, but the configured

Validation Criteria does not match the corresponding data in the certificate received from the

peer. The data configured must match exactly to the data in the certificate. The data is also case

sensitive.

unknown protocol message when trying to make an SSL/TLS connection

z This will be displayed when both sides of the TCP connection are configured as SSL/TLS

clients. Change one of the end points to act as an SSL/TLS server.

z One of the endpoints is not configured for SSL/TLS. Make sure both endpoints are configured

for SSL/TLS, verify that one is a client and the other is a server.

tlsv1 alert handshake failure or sslv3 alert handshake failure

z The remote site has an SSL/TLS error and is sending this message with an alert message. Look at

the error messages on the remote end and fix the problem indicated.

I/O Models

An I/O Digital or Relay controlled motor is starting/stopping

z Digital and Relay channels have automatically resetting fuses, meaning that if the circuit gets

overloaded and the fuse blows, it will automatically reset when the circuit cools down.

An A4R2 model is starting/stopping

z The A4R2 model can run at 55 degrees Celsius ambient temperature when the input voltage is

22VDC or below. If the input voltage exceeds 22VDC, the maximum ambient temperature will

drop into the range of 45-50 degrees Celsius to run successfully.

1 2 ... 438 439 440 441 442 443 444 445 446 447 448 ... 459 460

Commentaires sur ces manuels

Pas de commentaire

Perle Systems Sds4 Manuel d'utilisateur Page 443

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Perle Systems Sds4