Perle Systems Sds4 Manuel d'utilisateur télécharger pdf (Page 172)

100

101

171

Serial Port Profiles

Advanced Tab Field Descriptions

Configure the following parameters:

Break Length

When the IOLAN receives a command from its peer to issue a break signal,

this paramters defines the length of time the break condition will be asserted on

the serial port

Default: 1000ms (1 second)

Delay After Break This parameter defines the delay between the termination of a a break

condition and the time data will be sent out the serial port.

Default: 0ms (no delay).

Session Strings Controls the sending of ASCII strings to serial devices at session start and

session termination as follows;

z Send at Start—If configured, this string will be sent to the serial device

on power-up of the IOLAN or when a kill line command is issued on this

serial port. If the "monitor DSR" or "monitor DCD" options are set, the

string will also be sent when the monitored signal is raised.

Range: 0-127 alpha-numeric characters

Range: hexadecimal 0-FF

z Send at End—If configured, this string will be sent to the serial device

when the TCP session on the LAN is terminated. If multihost is

configured, this string will only be send in listen mode to the serial device

when all multihost connections are terminated.

z Range: 0-127 alpha-numeric characters

Range: hexadecimal 0-FF

z Delay after Send—If configured, will inset a delay after the string is sent

to the device. This delay can be used to provide the serial device with time

to process the string before the session is initiated or terminated.

Default: 10 ms

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 459 460

Commentaires sur ces manuels

Pas de commentaire

Perle Systems Sds4 Manuel d'utilisateur Page 172

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Perle Systems Sds4