Perle Systems Switch DS1 Manuel d'utilisateur télécharger pdf (Page 156)

156

Channels

Adding/Editing Additional Hosts

You can define a list of hosts that the I/O channel will communicate to or a primary/backup host.

Configure the following parameters:

Define additional

hosts to connect to

When this option is enabled, you can define up to 49 hosts/IOLANs that the

I/O channel or serial signal pin will attempt communicate to. With this mode of

operation, the I/O channel will connect to multiple hosts/IOLANs

simultaneously.

Default: Enabled

Add Button Click the Add button to add a host to the list of hosts that will be receiving

communication from the I/O channel or serial signal pin.

Edit Button Highlight an existing host and click the Edit button to edit a host in the list of

hosts that will be receiving communication from the I/O channel.

Delete Button Click the Delete button to delete a host to the list of hosts that will be receiving

communication from the I/O channel or serial signal pin.

Define a primary

host and backup...

When this option is enabled, you need to define a primary host that the I/O

channel will communicate to and a backup host, in the event that the I/O

channel loses communication to the primary host. The I/O channel will first

establish a connection to the primary host. Should the connection to the

primary host be lost (or never established), the I/O channel will establish a

connection the backup host. Once connected to the backup, the I/O channel will

attempt to re-establish a connection to the Primary host, once this is

successfully done, it gracefully shuts down the backup connection.

Default: Disabled

Primary Host Specify a preconfigured host that the I/O channel or serial signal pin will

communicate to.

Default: None

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 245 246

Pas de commentaire

Perle Systems Switch DS1 Manuel d'utilisateur Page 156