Perle-systems C-100-XXXXX Manuel d'utilisateur télécharger pdf (Page 4)

Fast Ethernet Media Converter – Installation Guide

4

Auto-Config Jumper (CM-100 only)

The Auto-Config jumper (J6) is located just below the Auto-MDIX

jumper (see above). Refer to the diagram below for labelling.

This jumper only applies to CM-100 modules.

Strapping pins 1 and 2 of the jumper will set the module in SW

mode and strapping pins 2 and 3 will set it in Auto Config mode.

Auto: When set to Auto the module will, at power-up, check its

internal flash memory to see if configuration information has

been downloaded to it from a management module. If so it will

use this as its running configuration. If there is no configuration

in flash it will read the settings of the DIP switches and use those

as its running configuration.

SW: When set to SW (Switch), the module will, at power-up,

read the settings of the DIP Switches and use those as it running

configuration. It will ignore any configuration information in its

flash memory.

NOTE: The default jumper setting is Auto

1 2 3 4 5 6 7 8 9 ... 18 19

Commentaires sur ces manuels

Pas de commentaire