Perle-systems C-100-XXXXX Manuel d'utilisateur Page 1

P/N 5500306-15 Perle Fast Ethernet Media Converter Module Installation Guide C-100-XXXXX Unmanaged Module CM-100-XXXXX Managed Module

Fast Ethernet Media Converter – Installation Guide 10 7. Remove the dust cap from the fiber connector and connect the fiber and copper cables. Re

Fast Ethernet Media Converter – Installation Guide 11 Installing the Simplex Fiber Cable • Locate a 100Base-X compliant simplex (1 strand) fiber

Fast Ethernet Media Converter – Installation Guide 12 Operation Status LED The Perle Fast Ethernet Media Converter modules have three single col

Fast Ethernet Media Converter – Installation Guide 13 Other Features Auto-MDIX: Auto-MDIX (automatic medium-dependant interface) detects the signa

Fast Ethernet Media Converter – Installation Guide 14 Troubleshooting General • Ensure the module is correctly seated to the backplane in the MCR

Fast Ethernet Media Converter – Installation Guide 15 Method 2: The fiber connection can also be verified by configuring the remote Media Converter

Fast Ethernet Media Converter – Installation Guide 16 Technical Specifications Power Input/Consumption 12V DC / 2.0 W Operating Temperature: 0 °

Fast Ethernet Media Converter – Installation Guide 17 C-100-S2SC120 CM-100-S2SC120 SM TX: 1550 RX: 1550 Min: 0 Max: 5 Min: -35 Max: -3 35

Fast Ethernet Media Converter – Installation Guide 18 Compliance Information FCC This product has been found to comply with the limits for

Fast Ethernet Media Converter – Installation Guide 19 Warranty / Registration Perle’s standard Lifetime Warranty provides customers with return to

Fast Ethernet Media Converter – Installation Guide 2 Overview This document contains instructions necessary for the installation and operation of t

Fast Ethernet Media Converter – Installation Guide 3 Installation The module comes equipped with a bank of DIP switches and jumpers for setting co

Fast Ethernet Media Converter – Installation Guide 4 Auto-Config Jumper (CM-100 only) The Auto-Config jumper (J6) is located just below the Auto-

Fast Ethernet Media Converter – Installation Guide 5 DIP Switches DIP Switch Settings Auto Negotiation (Switch 1) Switch Position Mode Up (defa

Fast Ethernet Media Converter – Installation Guide 6 Link Mode (Switch 2) Switch Position Mode Up (default) Link Pass-Through Mode Down Standard

Fast Ethernet Media Converter – Installation Guide 7 If the Media Converter has been set to Link Pass-Through mode, the effect will be the same as

Fast Ethernet Media Converter – Installation Guide 8 Unused (Switch 4) Pause (Switch 5) Switch Position Mode Up (default) Enabled Down Disabled

Fast Ethernet Media Converter – Installation Guide 9 Installing or Replacing Media Converter Modules Caution: Observe electrostatic discharge pr